Steering Angle Check

Place the front wheel on a turning radius gauge and measure the steering angle.
Standard value:

Fig 1: Measuring Steering Angle
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Steering Angle Specifications Chart
Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
If the steering angle is not within the standard value, adjust the toe-in.
Standard value: 0 plus/minus 3 mm (0 plus/minus 0.12 inch)

Fig 3: Adjusting Toe-In

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Adjust the toe-in by undoing the clip and turning the left and right tie rod turnbuckles by the same amount (in opposite directions).
NOTE: The toe will move out as the left turn buckle is turned toward the front of the vehicle and the right turnbuckle is turned toward the rear of the vehicle.