Primary Coil And Ignition Power Transistor Continuity Check

CAUTION: This test must be performed quickly (in less than 10 seconds) to prevent the coil from burning and the ignition power transistor from breaking.

NOTE: An analog-type ohmmeter should be used.

NOTE: Connect the negative probe of the ohmmeter to terminal 1.

As described in the chart below, perform a continuity check on the ignition coil and power transistor.

Fig 1: Checking Primary Coil And Ignition Power Transistor Continuity

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Continuity Table

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.