Anti-Lock Braking System (Abs)
- General Description
- Anti-Lock Braking System (Abs) Diagnosis
- Introduction To Anti-Lock Braking System Diagnosis
- Troubleshooting Strategy
- Trouble Code Diagnosis
- Diagnostic Trouble Code Chart
- Diagnostic Trouble Code Procedures
- Notes
- DTC 11,12,13,14: ABS Sensor (Open Circuit or Short Circuit)
- DTC 21, 22, 23, 24: ABS Sensor
- DTC 25: The Difference Diameter Tire
- DTC 31: Ignition switch (IG2) (Open Circuit)
- DTC 33 : Stoplight Switch System
- DTC 45,46: Select Solenoid Valve
- DTC 51: Valve Relay System (Short Circuit or ON Failure)
- DTC 52: Valve Relay System (Open Circuit or OFF Failure)
- DTC 61 : Master Cylinder Pressure Sensor System
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication with Scan Tool is not Possible. (Communication with ABS Only is not Possible.)
- INSPECTION PROCEDURE 2: When the Ignition Switch is Turned the "ON" Position (Engine Stopped or after Start-up), the ABS Warning Light does not Illuminate.
- INSPECTION PROCEDURE 3: The ABS Warning Light Remains Illuminated after the Engine is Started.
- INSPECTION PROCEDURE 4: When Ignition Switch is Turned to the "START" Position, the ABS Warning Light does not Illuminate.
- INSPECTION PROCEDURE 5: The ABS Warning Light Flashes Twice after the Ignition Switch is Turned to the "On" Position. The Light Illuminates When the Ignition Switch is Turned to the "Start" Position, and When the Ignition Switch is Returned to the "On" Position, it Flashes Once.
- INSPECTION PROCEDURE 6: Faulty ABS Operation
- Data List Reference Table
- Actuator Test Reference
- Check At M-ASTC-Ecu
- Special Tools
- On-Vehicle Service
- Abs Control Unit
- Wheel Speed Sensor
- G-Sensor
- Specifications