Power/Heated Mirrors - Except Evolution

• Operation
  • Remote Controlled Mirror
  • Heated Door Mirror Operation
• Special Tools
• Diagnosis
  • Heated Mirror
  • Symptom Chart
• Symptom Procedures
  • Inspection Procedure 1: All Heated Door Mirrors Do Not Operate
    • Circuit Diagram
    • Circuit Operation
    • Troubleshooting Hints
    • Diagnosis
      • Step 1: Check The Defogger
      • Step 2: Check The Battery Power Supply Circuit To The Remote Controlled Mirror (RH) Test At Remote Controlled Mirror (RH) Connector E-20
      • Step 3: Check The Remote Controlled Mirror (RH) Connector E-20 And Junction Block Connector C-214 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
      • Step 4: Check The Wiring Harness Between The Remote Controlled Mirror (RH) Connector E-20 (Terminal No. 1) And Junction Block Connector C-214 (Terminal No. 3)
  • Inspection Procedure 2: Right Or Left Heated Door Mirror Does Not Operate
    • Circuit Diagram & Connector Identification
    • Circuit Operation
    • Troubleshooting Hints
    • Diagnosis
      • Step 1: Verify The Operation Of Each Heated Door Mirror
      • Step 2: Check The Heated Door Mirror (LH)
      • Step 3: Check The Ground Circuit To The Door Mirror (LH)
      • Step 4: Check The Remote Controlled Mirror (LH) Connector E-19 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
      • Step 5: Check The Wiring Harness Between The Remote Controlled Mirror (LH) Connector E-19 (Terminal 4) And Ground
      • Step 6: Check The Remote Controlled Mirror (LH) Connector E-19 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
      • STEP 7. Check the wiring harness between the remote controlled mirror (LH) connector E-19 (terminal 1) and junction block connector C-214 (terminal 3).
      • Step 8: Check The Heated Door Mirror (RH)
      • Step 9: Check The Ground Circuit To The Door Mirror (RH)
      • Step 10: Check The Remote Controlled Mirror (RH) Connector E-20 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
      • Step 11: Check The Wiring Harness Between The Remote Controlled Mirror (RH) Connector E-20 (Terminal No. 4) And Ground
      • Step 12: Check The Remote Controlled Mirror (RH) Connector E-20 For Loose, Corroded Or Damaged Terminals, Or Terminals Pushed Back In The Connector
      • Step 13: Check The Wiring Harness Between The Remote Controlled Mirror (RH) Connector E-20 (Terminal No. 1) And Junction Block Connector C-214 (Terminal No. 3)
• Removal & Installation
  • Door Mirror
    • Notes
    • Removal Service Point
      • A) Mirror Removal
    • Installation Service Point
      • A) Mirror Installation
• Inspection
  • Electric Remote Control Mirror Operation Check (Vehicles Without Heated Mirror
  • Electric Remote Control Mirror Operation Check (Vehicles With Heated Door Mirror)
  • Door Mirror Control Switch Continuity Check
  • Heated Door Mirror Check
• Wiring Diagrams