LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2003 >> Galant ES, 2.4 G >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Remote Keyless Entry Systems >> Programming >> ANSWERBACK Function Customization >> Activating/Deactivating Hazard Answerback Function Using RKE Transmitter In Addition To Scan Tool Or Jumper Wire

Activating/Deactivating Hazard Answerback Function Using RKE Transmitter In Addition To Scan Tool Or Jumper Wire

CAUTION: To prevent damage to scan tool, always turn ignition off before connecting or disconnecting scan tool.

Enter the hazard answerback customize mode by observing the appropriate of steps  1 through  3 .

  1. If the ETACS-ECU enters the customize mode, its tone alarm will sound once. Connect Scan Tool (MB991502) to the data link connector terminal No. 1. See Fig 1 . Turn the ignition switch to LOCK (OFF) position. Close the driver's side door. Leave the windshield washer switch ON for at least 10 seconds. Then the ETACS-ECU tone alarm will sound once.
  2. If the transmitter LOCK switch is pushed consecutively twice within 2 seconds, the ETACS-ECU tone alarm will sound, indicating that the hazard answerback function can be enabled or disabled when the doors are locked.
    • Enable the hazard answerback function when the doors are locked. The ETACS-ECU tone alarm will sound once.
    • Disable the hazard answerback function when the doors are locked. The ETACS-ECU tone alarm will sound twice.
  3. If the transmitter UNLOCK switch is pushed consecutively twice within 2 seconds, the ETACS-ECU tone alarm will sound, indicating that the hazard answerback function can be enabled or disabled when the doors are unlocked.
    • Enable the hazard answerback function when the doors are unlocked. The ETACS-ECU tone alarm will sound once.
    • Disable the hazard answerback function when the doors are unlocked. The ETACS-ECU tone alarm will sound twice.
  4. Exit the hazard answerback customize mode by observing the following procedure. Disconnect scan tool from the data link connector or disconnect data link connector terminal No. 1 from ground. See Fig 1 . Turn the ignition switch to position other than LOCK (OFF), or remove the ignition key. Open the driver's side door. If any operation is not done for at least 3 minutes after the ETACS-ECU has entered the customize mode, the hazard answerback customize mode will be canceled automatically.
Fig 1: Identifying Data Link Connector (DLC) Terminals
G99I05997Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.