Toe-In Adjustment: Front
WARNING: This page does not describe the selected car, but rather 13 other vehicles, including the 2000 Mitsubishi Montero Sport, 2000 Mitsubishi Montero, 2000 Mitsubishi Mirage, 2000 Mitsubishi Galant, and 2000 Mitsubishi Eclipse. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
On Eclipse Spyder models, rear wheel alignment should be performed prior to adjusting front toe-in.
Check front toe-in. See appropriate WHEEL ALIGNMENT SPECIFICATIONS table. If front toe-in is not within specification, remove clips, and turn left and right tie rod turnbuckles same amount, but in opposite directions. Toe will move out as left turnbuckle is turned toward front of vehicle, and right turnbuckle is turned toward rear of vehicle. Recheck front toe-in.
NOTE:
For each turn of left and right tie rod turnbuckles, toe-in changes about 1.08 degrees. Tie rod outer turnbuckles have left-hand threads. Ensure length of left and right tie rods are within .20" (5.0 mm) of each other.