Ignition Switch In On Position, Warning Light Remains On
- Disconnect ABS ECU connector. If warning light illuminates, go to next step. If ABS warning light does not illuminate, replace ABS ECU and go to step 3 .
- Inspect Light Green/Black wire and connectors between terminal No. 21 at ABS ECU connector and terminal No. 24 at instrument cluster (ABS warning light) connector C-42. See Figure and Figure . Check condition of connector C-94. Repair any damage found and go to next step.
- Confirm ABS warning light turns off 3 seconds after ignition switch is turned to RUN position.