LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2000 >> Eclipse GS, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock/Traction Control >> Self-Diagnostic System >> Retrieving Diagnostic Trouble Codes >> Using Voltmeter (AWD)

Using Voltmeter (AWD)

  1. To retrieve stored DTCs, locate Data Link Connector (DLC) located under driver side of dash. Turn ignition switch off. Connect analog voltmeter between DLC terminal No. 8 (ABS) and either terminal No. 4 or 5 (ground). See Fig 1 . Go to next step.
  2. Start engine. Stored DTCs will be indicated by sweeps of voltmeter needle. Long sweeps indicate first digit of DTC; short sweeps indicate second digit. If more than one fault is present, lowest number DTC will be given first. After DTC(s) has been retrieved, test indicated component and/or related circuit (if necessary). See appropriate DTC table under DTC DEFINITION  .
Fig 1: Identifying Data Link Connector Test Terminals
G93J00264Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals