Test 107A - Wiper Motor Intermittent Speed Operation
WARNING: This page is about a different car, the 1995 Eagle Vision, 1995 Dodge Intrepid, 1995 Chrysler New Yorker, 1995 Chrysler LHS, and 1995 Chrysler Concorde. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
For connector terminal identification, see CONNECTOR IDENTIFICATION
. For wiring diagrams, see appropriate article in ENGINE PERFORMANCE:
- WIRING DIAGRAMS - 3.3L
- WIRING DIAGRAMS - 3.5L
- Perform TEST VER-1 after each repair.CAUTION: Always turn ignition off prior to disconnecting any module connector.
- Turn ignition on. Move wiper switch through all 6 different delay (intermittent speed) levels. If all delay levels do not fail, go to step 3). If all delay levels fail, go to next step.
- Using scan tool, read wiper switch status. Move wiper switch from OFF position through all 6 different delay levels. If scan tool voltage does not increase proportionally between INTRMT WIPE 0V and 5V (volts), replace multifunction switch. If scan tool voltage does increase proportionally, replace BCM.
- Using scan tool, read wiper switch status at failed intermittent wiper switch position(s). If voltage is present at failed position, replace BCM. If voltage is not present at failed position, replace multifunction switch.