Section 56 (Engine Controls - System/Component Tests - 1.5L): Introduction

WARNING: This page is about a different car, the 1995 Mitsubishi Mirage and 1995 Eagle Summit. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Testing individual components does not isolate shorts or opens. Perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with minimum 10-megohm input impedance, unless stated otherwise in test procedure. Use ohmmeter to isolate wiring harness shorts or opens.

Before testing separate components or systems, perform procedures in BASIC TESTING - 1.5L article. Since many computer-controlled and monitored components set a trouble code if they malfunction, also perform procedures in appropriate TESTS W/CODES article below.

TESTS W/CODES - OBD-I (1.5L) (for Federal emissions)
TESTS W/CODES - OBD-II (1.5L) (for California emissions)