Rear Differential Control Unit
Remove rear seat and remove rear differential control unit. Do not disconnect control unit harness connector. Backprobe harness connector. Measure voltage between each individual terminal and ground terminal No. 6 (Black wire). See Fig 1 and REAR DIFFERENTIAL CONTROL UNIT PIN VOLTAGE CHART. If after all tests have been completed system is not operating properly, substitute rear differential control unit with known good unit and retest.
REAR DIFFERENTIAL CONTROL UNIT PIN VOLTAGE CHART
| Wire Color (Terminal ID) | Function/Description | Voltage Value (DC Volts Unless Otherwise Specified |
|---|---|---|
| Blue/Red | Rear Differential Lock Switch (OFF) | KOEO - Battery Voltage With Transfer In "N" |
| Yellow/White | Vehicle Speed Sensor | KOER - 5 Volts With Wheels Rotating |
| Blue/Yellow | Ignition Switch (IG1) | Ignition Off - 0 Volt Ignition On - Battery Vltge |
| Red | Rear Differential Lock Air Pump | KOEO - Battery Voltage When Pumping Air |
| Red | Rear Differential Lock Air Pump | KOEO - 0 Volt When Releasing Air |
| Blue/White | Center Differential Lock Switch | KOEO - Battery Voltage With Transfer Unlocked |
| Blue/White | Center Differential Lock Switch | KOEO - 0 Volt With Transfer Locked |
| Red/Blue | Rear Differential Lock Detection Switch | KOEO - Battery Voltage/Differential Unlocked |
| Red/Blue | Rear Differential Lock Detection Switch | KOEO - 0 Volt With Differential Locked |
| Blue/Yellow | Rear Differential Lock Switch (ON) | KOEO - 0 Volt |
| Red/Yellow | Rear Differential Lock Indicator Light | KOEO - 0 Volt With Differential Locked |
| Red/Yellow | Rear Differential Lock Indicator Light | KOEO - Battery Voltage With Differential Locked |