RWD Models: Removal
- Disconnect negative battery cable. Remove front exhaust pipe. On Montero, remove transfer case shift lever knob, dust boot and retainer plate or console. Remove transfer case gearshift assembly.
- On all models, raise and support vehicle. Remove undercarriage cover and/or skid plate(s). Drain transmission and transfer case (if applicable). Place reference mark on drive shaft(s) and remove. Disconnect all external solenoid and switch connections.
- Disconnect speedometer cable and control cables at transmission. Remove starter and bellhousing cover. Place reference mark on torque converter and drive plate for reassembly reference. Remove torque converter bolts.
- Disconnect transmission cooler lines. Remove oil filler tube. Secure transmission on a jack. Raise transmission slightly to take weight off mount. Remove crossmember-to-mount bolts and crossmember.
- Remove transfer case mounting bracket and mount (if equipped). Remove transmission-to-engine mounting bolts. Carefully lower transmission from vehicle.
CAUTION:
Ensure torque converter is fully seated in transmission before installation.