LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1992 >> Montero LS >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Overhaul - V4AW2 >> Component Disassembly & Reassembly >> Center Support Assembly >> Inspection

Center Support Assembly: Inspection

  1. Clean all components (except discs) with solvent. Dry with compressed air. Inspect plates and discs for flaking or burnt areas. If disc lining is peeling or discolored, replace disc as necessary. Inspect return springs for wear, damage or collapsed coils.
  2. Measure inside diameter of center support bushing. Maximum inside diameter is 1.435" (36.46 mm). If inside diameter is greater than specified, replace center support. Measure inside diameter of planetary sun gear bushings. Maximum inside diameter is .850" (21.58 mm). If inside diameter is greater than specified, replace planetary sun gear.
  3. Using a feeler gauge, measure clearance between planetary pinion gear and planetary gear case. Standard clearance is .008-.020" (.20-.50 mm). If clearance is not as specified, replace planetary gear assembly.
CAUTION: Clutch discs should be soaked in ATF for at least 2 hours prior to installation. Lubricate all parts with ATF.
scientia non olet · About LEMON Manuals