Combination Switch Continuity Tests

Remove combination switch from steering column if necessary. See COMBINATION SWITCH R & I  . Using an ohmmeter, check for continuity between terminals of each connector in each switch position. See COMBINATION SWITCH CONNECTORS CONTINUITY TEST  . SeeFig 1 through Fig 4 . Ensure wire leads are not being pulled while moving switch from one position to another. Ensure switch lever works freely (without binding).

Fig 1: Identifying Terminals of Combination Switch Connectors

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 2: Headlight & Dimmer/Passing Switch Testing Positions

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 3: Hazard & Turn Signal Switch Testing Positions

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.

Fig 4: Wiper & Washer Switch Testing Positions

Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.