LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 1987 >> Precis Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Body - Lancer Evolution) >> Door >> Specification(S) >> On-Vehicle Service >> Power Window Operating Current Check

Power Window Operating Current Check

WARNING: This page is about a different car, the 2008 Mitsubishi Lancer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the power window fuse, and connect a multimeter as shown in the illustration.
  2. Raise the power window to measure the current during operation.

    Standard value (A) : 7 A or less [Power supply voltage 14.5 ± 0.5V, 25°C (77°F)] 

    NOTE: If the power supply voltage does not meet the standard value, check and repair the generator and the battery. Then carry out this check again.
  3. If the operation current is outside the standard value, refer to TROUBLESHOOTING STRATEGY  .
    Fig 1: Identifying Power Window Fuse
    G05384152Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
scientia non olet · About LEMON Manuals