Additional work for camber correction

NOTE: The camber adjustment is performed only with the REPLACEMENT OF THE SWIVEL BEARING . There are 3 different swivel bearings for this!

Attention !

Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment!

NOTE: The swivel bearing may only be replaced if the camber is outside the specified tolerance after toe adjustment.

Preliminary work needed :

Adjust TOE-IN .

Check camber values; if necessary, replace SWIVEL BEARING with over- or under-dimension variant.

NOTE: The camber correction swivel bearings are only identifiable via MINI part number (1).
Also refer to the MINI applicable BMW parts catalogue!

These camber correction swivel bearings are used to correct the camber values by 30 min. To be used only if the tolerance values are exceeded or undershot!

Courtesy of BMW OF NORTH AMERICA, INC.

After setting :

Check directional stability of car; if necessary, repeat TOE-IN .