00 00... CBS reset
The CBS maintenance jobs can be reset in the car. It is always recommended to reset the CBS jobs via the diagnostic system.
It is only possible to code the country-specific statutory intervals with the diagnostic system.
Front/rear brake service:
A CBS reset is only possible in the vehicle with a sanded brake pad wear sensor (CBS display in CID active).
With a non-sanded brake pad wear sensor (no CBS display in CID), CBS reset is only possible with the diagnostic system.
Other known causes of CBS reset problems:
- Parking brake engaged
- Brake pedal pressed
CBS reset with diagnostic system:
To be able to check or correct the vehicle's on-board date properly, the diagnostic system requires the correctly set tester system date!
The jobs may only be reset after the service activity has been completed.
The CBS jobs can be reset via the diagnostic system on the following path:
- Service functions
- Maintenance
- CBS reset
CBS reset in the car:
On the vehicle, service operations can be reset at the dashboard.
On-board date must be correctly set.
A reset is only possible in the car if:
- no CC message is present
- availability of the service job is under 90%
Resetting of a service job must always be carried out after a maintenance measure has been completed.
The resetting process is interrupted it the time is exceeded or if a terminal is changed.
- Switch the ignition on.
- Press the trip distance recorder reset button (1) (referred to as button in the following) for approx. 10 seconds until the 1st service job is displayed in the display (2) . Bring up the next item by briefly pressing the button again. Select the desired service job.
- If a reset is possible, this is displayed in the instrument cluster as "Reset possible". Press the button for 3 s to start the reset.
- Confirm text message "Perform reset?" by pressing the button for 3 seconds again. The status of the reset is signaled in the display by a progress bar and in text as "Reset in progress".
- The reset is confirmed as "Reset successful" after completion.
CBS reset of required vehicle inspections/tests:
Input the target date for the statutory vehicle inspection by clicking on the perimeter with the controller in the CBS main menu of the Central Information Display under:
- Vehicle information
- Vehicle status
- Service requirements
- Vehicle inspection
- Enter service appointment
The target month or the target year can be set and acknowledged by turning and pressing.