61 31 117 Removing and installing/replacing power window switch (driver's side)

WARNING: This page is about a different variant/trim than selected.

Special tools required:

IMPORTANT: Carry out the following operation carefully so as to avoid damaging the door trim panel and switch.
If necessary, tape off working area.

Removal:

Lever power window switch (1) out of armrest (2) in arrow direction using special tool 00 9 327 .

Disconnect connector underneath and remove power electric windows switch (1).

Fig 1: Locating Lever Power Window Switch Out Of Armrest

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Release detents on both sides and feed power window switch (1) out of trim (2).

Join switch spare part for power electric windows (1) in cover (2).

NOTE: Ensure detent of switch for power electric windows (1) in cover (2) is correct.

Fig 2: Removing Detents On Both Sides

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

NOTE: The guide (1) and detents (2) on the trim (3) must not be damaged or missing.

Fig 3: Locating Detents On Trim

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector.

Join power electric windows switch (1) in armrest (2) in arrow direction.

NOTE: Make sure that the power window switch is correctly seated in the armrest.

Fig 4: Joining Power Electric Windows Switch In Armrest

Courtesy of BMW OF NORTH AMERICA, INC.