32 00... Shifting vehicle into normal position

WARNING: This page is about a different variant/trim than selected.

Preliminary work needed:

Check compliance with TEST CONDITIONS , repair vehicle if necessary.

Check vehicle interior and trunk (including spare wheel well) for load status, if applicable, unload car

Introduce DIN load into vehicle.

Vehicle fully assembled for normal operation with: 2 x 68 kg on front seats (seats in central position), 1 x 14 kg in trunk (center) and full fuel tank.

Determine VEHICLE RIDE HEIGHT .

NOTE: If the vehicle ride height is not inside the tolerance (refer to TECHNICAL DATA ), the vehicle must be repaired (coil spring/leakage).