61 31 008 Removing and installing (replacing) steering column switch cluster

IMPORTANT: Shift wheels into straight-ahead position and do not alter this position during the repair work.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.

Preliminary work needed:

Remove steering wheel
Remove the top section of steering column casing
Remove steering column shroud lower section

Removal:

G09949538

Courtesy of BMW OF NORTH AMERICA, INC.

Unscrew the screws (1).

Remove steering column switch cluster (2) in arrow direction.

G11110116

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock and disconnect connector (1) on steering column switch cluster (2).

Installation:

G11110116

Courtesy of BMW OF NORTH AMERICA, INC.

Connect connector (1) to steering column switch cluster (2).

G09947071

Courtesy of BMW OF NORTH AMERICA, INC.

NOTE: Check neutral position of coil spring on steering column switch cluster.
Neutral position is correct only when the green or yellow mark (1) is clearly visible!

G11649827

Courtesy of BMW OF NORTH AMERICA, INC.

Install steering column switch cluster in arrow direction.

Retain steering column switch cluster pressed firmly against the steering column.

Tighten screws (1 to 4) in the order displayed.

Tightening torque 61 31 3AZ.