61 13... Socket housings, 2x21-, 2x27-pin, Hybrid Systems MQS/MPQ, Elo/Elo Power

Manufactured by AMP:  The following bushing housing types without single conductor seal can be fitted into the socket housings:

• MQS (Micro Quadlock System)
• MPQ, width 2.8 mm (Micro Power Quadlock)
• MPQ, width 5.2 mm (Micro Power Quadlock)

Manufactured by Siemens:  The following bushing housing types without single conductor seal can be fitted into the socket housings:

• Elo (electrical contact)
• Elo Power 2.8 mm width (electrical contact for heavy loads)
• Elo Power 5.2 mm width (electrical contact for heavy loads)

Raise lock (1) on housing (2).

Push contact carrier (3) from rear out of housing.

NOTE: The second contact carrier is pushed out in the same way.
Pushing out the contact carrier releases the secondary locks of the socket contacts.

Fig 1: Pushing Contact Carrier From Rear Out Of Housing

Courtesy of BMW OF NORTH AMERICA, INC.

Hold down snap-in hooks (1) of contact bushing in opening of contact carrier with a small screwdriver.
Pull wire with contact bushing in arrow direction as far as secondary lock (2).

Fig 2: Pulling Wire With Socket Contact As Far As Secondary Lock

Courtesy of BMW OF NORTH AMERICA, INC.

Hold down snap-in hooks in secondary lock (1) again and pull cable with contact bushing (2) completely out of contact carrier (3).

Fig 3: Pulling Wire With Socket Contact Out Of Contact Carrier

Courtesy of BMW OF NORTH AMERICA, INC.