61 35 360 Removing and installing control unit for camera-based driver support systems (KAFAS)
IMPORTANT:
Read and comply with notes on protection against electrostatic damage (ESD PROTECTION) .
Preliminary work needed:
- Clamp off BATTERY LEAD FROM NEGATIVE CONNECTION POINT
- Remove right glove compartment
Removal:
Release detent on equipment holder.
Feed out KAFAS control unit (1) from equipment holder (2).
Unlock connector (1) on KAFAS control unit (2) and disconnect.
Installation:
Connect connector (1) to KAFAS control unit (2).
Join KAFAS control unit (1) in equipment holder (2).
NOTE:
Ensure detent of KAFAS control unit (1) is correct in equipment holder (2).