Section 4309 (Steering And Wheel Alignment - Repair - F32)
WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 2016 BMW 435i xDrive, 2016 BMW 435i, 2016 BMW 428i xDrive, 2016 BMW 428i, and 2015 BMW 435i xDrive. However, it is still accessible from the selected car via links, so may be relevant.
- Electronic Chassis Alignment
- 00 Danger of poisoning if oil is ingested/absorbed through the skin
- 00 Risk of injury if oil comes into contact with eyes and skin
- 00 Safety information for working on vehicles with automatic engine start-stop function (MSA)
- 00 Safety instructions for handling oil
- 32 00... Additional work for camber correction (435i xdr N55)
- 32 00... Additional work for camber correction (428i, 428ixdr N20/N26, 435i N55)
- 32 00 620 Adjusting rear axle
- 32 00 601 Adjusting toe-in on front axle
- 32 00 150 Carry out wheel alignment Kinematics Diagnosis System with vehicle load up to design position
- 31 00... Front axle and steering: wheel/chassis alignment check must be carried out after the following work
- 32 00... General chassis and suspension definitions
- 32 00... General information and definitions
- 32 00... Identification of suspension without label
- 32 00 150 KDS chassis/wheel alignment check with vehicle load up to design position
- 32 00... KDS data statuses
- 32 00 155 KDS wheel alignment check with ride height measurement without vehicle load
- 32 00 155 Kinematics Diagnosis System wheel alignment with ride height measurement without loading the vehicle
- 31 33... Measuring vehicle ride height
- 32 00... Moving vehicle into design position
- 32 00... Moving vehicle into normal position
- 32 00... Notes on replacement of steering gear/steering column/steering shaft following accident damage
- 33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
- 34 52.. Start-up of ICM control unit
- 32 00... Test conditions for chassis/wheel alignment check
- 72 00... Safety regulations for handling components with gas generators
- 72 12... Procedure after airbag deployment as result of an accident
- Mechanical Steering Gear
- Steering Gear With Servo Unit
- Steering Arms, Tie Rods, Steering Damper
- Steering Column
- 32 31 070 Removing and installing/replacing lower section of steering shaft (435i N55)
- 32 31 070 Removing and installing/replacing lower section of steering shaft (428i xdr N20/N26)
- 32 31 020 Removing and installing/replacing lower section of steering column shroud
- 32 31 070 Removing and installing/replacing steering bottom steering shaft (N20 AWD vehicle)
- 32 31 090 Removing and installing/replacing steering column
- 32 31 003 Removing and installing/replacing upper section of steering column shroud
- 32 31 241 Replacing steering column adjustment lever
- 32 31 102 Replacing steering shaft sleeve
- Steering Wheel
- 32 33 010 Removing and installing (replacing) M sports steering wheel
- 32 33 010 Removing and installing/replacing sport steering wheel
- 32 33 000 Removing and installing/replacing steering wheel
- 32 33 016 Replacing design cover for M sports steering wheel
- 32 33... Replacing design cover for sports steering wheel
- Steering Wheel For Airbag
- 72 00... Safety regulations for handling components with gas generators
- 72 12... Procedure after airbag deployment as result of an accident
- 32 34 020 Removing and installing/replacing airbag unit
- 32 34 030 Removing and installing/replacing airbag unit (M sports steering wheel)
- 32 34 030 Removing and installing/replacing airbag unit (sport steering wheel)
- Pump And Oil Supply
- Electronic Power Steering