32 34 020 Removing And Installing/Replacing Airbag Unit
WARNING: This page is about a different car, the 2010 BMW X5, 2009 BMW X5, 2008 BMW X5, and 2007 BMW X5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Observe the following instructions to avoid any risk of injury by the airbag unit.
- Comply with safety regulations for handling components with gas generators.
- Do not exert any force on the airbag unit.
- Use only specified tools for releasing the airbag unit.
NOTE:
Incorrect handling may result in triggering of the airbag unit and thereby cause serious injury.
IMPORTANT:
Steering wheel
must be replaced if airbag unit has been triggered!
Follow procedure after airbag triggering.
Follow procedure after airbag triggering.
Necessary preliminary tasks:
- Disconnect battery negative lead . See 12 00... INSTRUCTIONS FOR DISCONNECTING AND CONNECTING BATTERY .
Insert Torx screwdriver T30 (1) at an angle into concealed opening on reverse side of steering wheel until a spring resistance is felt (approx. 2 cm).
Increase pressure with Torx screwdriver T30 (1) on spring leg until airbag unit is unlocked.
Repeat procedure on other side.
Installation:
Make sure electrical leads are correctly positioned.
Snap airbag unit with uniform pressing force plane-parallel in direction of steering column shaft into steering wheel.
WARNING:
Danger of injury!
Airbag unit may only be set down with the airbag itself facing upwards.
Airbag unit may only be set down with the airbag itself facing upwards.
Tilt airbag unit (1) towards rear.
Disconnect plug connections (2) and remove airbag unit (1). See 72 12... OVERVIEW OF AIRBAG MODULES, AIRBAG CONTROL UNIT, BELT TENSIONERS .
Installation:
Connect plugs to connections of same color on airbag unit.