32 31 020 Removing and installing / replacing lower section of steering column trim
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Unclip panel for pedals in area of steering column trim, see 51 45 185 REMOVING AND INSTALLING/REPLACING TRIM FOR PEDAL ASSEMBLY .
Move steering column in "top" and "extended" position.
Remove expander rivets (1).
NOTE:
Press pin approx. 5 mm into expander rivet (1).
Installation:
Expander rivet can be reused. Insert rivet and push in pin until flush.
Release adjusting lever (2) for steering column.
Reach into opening underneath and pull off lower section of steering column trim (3) towards bottom.
Installation:
Catch (1), guide (2), pin (3) and lock (4) must not be damaged.
Insert pin (3) at both ends into bore until lower section of steering column trim can be heard to engage with upper section via lock (4).
Press lower section of steering column trim against steering column until catch (1) locks.