32 13 066 Replacing active front steering hydraulic steering gear: Notes
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2016 BMW 760Li, 2015 BMW 760Li, 2014 BMW 760Li, 2013 BMW 760Li, and 2012 BMW 760Li. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
DANGER OF POISONING
if oil is ingested/absorbed through the skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
RISK OF INJURY if oil comes into contact with eyes and skin!
IMPORTANT:
Adhere to the utmost cleanliness. Do not allow any dirt to enter the hydraulic system.
Seal connections and lines immediately after removal with sealing plugs.
Seal connections and lines immediately after removal with sealing plugs.
Necessary preliminary tasks:
- Draw off and dispose of hydraulic fluid from fluid reservoir
- Remove underbody protection at FRONT and REAR .
- Remove COVER FOR STEERING ASSEMBLIES on left and right
- Remove TRACK ROD END ON BOTH SIDES FROM SWIVEL BEARING
- Remove lower section of steering spindle from steering gear. See REMOVING AND INSTALLING/REPLACING UNIVERSAL JOINT WITH CORRUGATED TUBING .
- Remove TRACK ROD END AT BOTH ENDS OF TRACK ROD
- Version with Dynamic Drive (F01/F02/F07):
- Remove FRONT ANTI-ROLL BAR
- Remove expansion hose
Slacken nut (1).
Tightening torque 32 41 7AZ .
Release screw (2) on bracket.
Tightening torque 32 41 7AZ .
Release screw (3).
Tightening torque 32 00 1AZ .
Unlock plug connections (1) and disconnect.
Pull hydraulic steering gear towards front a little.
Unfasten plug connection (1) and disconnect.
Release screw (2) and remove lines (3) from hydraulic steering gear.
Tightening torque 32 41 5AZ .
Remove power steering gear in downward direction.