LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2014 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 21 (Engine Controls - Remove/Install/Overhaul) >> Fuel System >> Fuel Pressure Regulator >> Removal & Installation (V8)

Removal & Installation (V8)

WARNING: This page does not describe the selected car, but rather 12 other vehicles, including the 1997 BMW Z3, 1997 BMW M3, 1997 BMW 840Ci, 1997 BMW 740iL, and 1997 BMW 740i. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fuel pressure regulator is located at rear of intake manifold. Remove engine cover. See Figure. Remove coolant expansion tank and BMW diagnostic connector (if necessary). Disconnect vacuum hose from pressure regulator. Remove circlip and pull pressure regulator out of fuel rail.
  2. To install, reverse removal procedure. Replace "O" rings on regulator and lubricate with petroleum jelly. Install regulator in fuel rail. Compress circlip and engage tabs of circlip into fuel rail.
scientia non olet · About LEMON Manuals