86 21 ... Installing Sponge Rubber Seal

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Removing old sponge rubber seal: Pull off old sponge rubber seal. Remove remaining traces of adhesive with universal cleaner, refer to BMW Operating Fluids.

Sponge rubber seal runs along area marked gray (1).

Fig 1: Identifying Gray Marked Area Of Rubber Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Lay sponge rubber seal (1) in middle of hood contact surface (2).

Installation:

Degrease contact surface (2) with benzine and rub down with a dry cloth. Stick on sponge rubber seal (1) according to manufacturer's instructions. Position end face of seal (1) in a straight area.

Fig 2: Identifying Rubber Seal In Middle Of Hood Contact Surface

Courtesy of BMW OF NORTH AMERICA, INC.