LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2013 >> Cooper Base, 2D Convertible, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Steering Column - Repair) >> Removal & Installation >> Steering Angle Sensor >> Removal

Steering Angle Sensor: Removal

WARNING: This page does not describe the selected car, but rather 37 other vehicles, including the 2006 BMW M3, 2005 BMW M3, 2004 BMW M3, 2004 BMW 330xi, and 2004 BMW 330i. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove trim panel for pedal assembly. See TRIM PANEL FOR PEDAL ASSEMBLY .
  2. Remove lower section of steering spindle. See STEERING SPINDLE LOWER SECTION .
  3. Pull upper section of steering spindle towards interior. See Fig 1.
  4. Press crash disk (3) off crash sleeve (2). Lift crash sleeve (2) out of groove of steering spindle upper section. Push steering spindle upper section into steering column. Remove crash disk (3), crash sleeve (2) and bushing (1). See Fig 2.
  5. Slacken nut (1) for sliding piece. Remove screw (3) with washer (2). See Fig 3.
  6. Pull down steering column. Press down both locking hooks. Detach steering angle sensor. See Fig 4.
  7. Press down locking hooks. Remove locking element. See Fig 5.
Fig 1: Pulling Upper Section Of Steering Spindle
G00175154Courtesy of BMW OF NORTH AMERICA, INC.
Fig 2: Removing Crash Disk
G00175155Courtesy of BMW OF NORTH AMERICA, INC.
Fig 3: Locating Sliding Piece Fasteners
G00175156Courtesy of BMW OF NORTH AMERICA, INC.
Fig 4: Detaching Steering Angle Sensor
G00175157Courtesy of BMW OF NORTH AMERICA, INC.
Fig 5: Removing Locking Element
G00175158Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals