13 62 594 Removing and installing/replacing pressure sensor on right intake plenum (N63)

WARNING: This page does not describe the selected car, but rather 50 other vehicles, including the 2016 BMW M5, 2016 BMW ActiveHybrid 5, 2016 BMW 550i xDrive, 2016 BMW 550i, and 2016 BMW 535i xDrive. However, it is still accessible from the selected car via links, so may be relevant.

Necessary preliminary work:

Read out DME fault memory.
Switch off ignition.
Remove ELECTRONICS BOX .
Draw off A/C SYSTEM .
Secure ENGINE in installation position.

Release screw (1).

Tightening torque 64 53 3AZ .

Detach A/C line (2) and place to one side.

Replace sealing ring on A/C line.

Fig 1: Identifying Refrigerant Line And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Unlock connector (1) and remove.

Release screws (2) with a reversible ratchet, extension, universal joint and a magnetic Torx socket.

Tightening torque 13 62 2AZ .

Pull pressure sensor (3) out of left intake plenum.

Installation note:

Coat sealing ring with lubricant.

Fig 2: Identifying Pressure Sensor Connector And Screws

Courtesy of BMW OF NORTH AMERICA, INC.

Installation note:

Delete fault memory.