61 31 014 Removing and installing/replacing Start/Stop switch
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Incorrectly installed start/stop switch may cause the start/stop switch or MSA button to jam.
In the case of a fault message "Jammed start/stop switch or MSA button" check before replacing whether the start/stop switch has been correctly installed in the cover and is de-energized!
If necessary install the existing start/stop switch again and perform a functional check!
In the case of a fault message "Jammed start/stop switch or MSA button" check before replacing whether the start/stop switch has been correctly installed in the cover and is de-energized!
If necessary install the existing start/stop switch again and perform a functional check!
Necessary preliminary tasks:
Release screws (1) and remove Start/Stop switch (2).
Installation note:
Only F10/F11/F12/F13/F18:
The tab of the start/stop switch (1) be installed below the tab (2)!