61 31 008 Removing and installing steering column switch cluster (SZL)
WARNING: This page does not describe the selected car, but rather 21 other vehicles, including the 2017 BMW 550i GT xDrive, 2017 BMW 535i GT xDrive, 2017 BMW 535i GT, 2016 BMW 550i GT xDrive, and 2016 BMW 535i GT xDrive. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Move wheels into straight-ahead position and do not alter this position during the repair work.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Do not under any circumstances turn the steering column switch cluster when the steering wheel is removed.
Necessary preliminary tasks:
- Remove steering wheel. See STEERING WHEEL or SPORT STEERING WHEEL .
Unclip steering column shroud upper section and lower section (1).
Unfasten screws (2).
Tightening torque 61 31 3AZ .
Remove steering column switch cluster (3) in direction of arrow.
Installation note:
Not applicable to F25.
Carry out STEERING ANGLE SENSOR ADJUSTMENT .
On vehicles with active steering, steering angle sensor adjustment is performed by means of START-UP /alignment of the active steering.
Disconnect plug connection (1).
Remove steering column switch cluster (2).
Replacement
Not applicable to F25.
- Carry out VEHICLE PROGRAMMING/ENCODING
- Carry out STEERING ANGLE SENSOR ADJUSTMENT
- Vehicles with active steering:
- Steering angle sensor adjustment is performed by means of START-UP/ADJUSTMENT of active front steering.