17 00 005 Draining and adding coolant (N63): Notes
WARNING: This page is about a different car, the 2011 BMW 750xi, 2011 BMW 750Lxi, 2010 BMW 750xi, and 2010 BMW 750Lxi. However, it is still accessible from the selected car via links, so may be relevant.
Special tools required
WARNING:
Risk of scalding!
Only carry out repair work on the cooling system after the engine has cooled down!
Only carry out repair work on the cooling system after the engine has cooled down!
IMPORTANT:
Lifetime coolant filling:
In the case of other removal work involving the draining of part quantities of coolant, replace these quantities which have been drained with new coolant.
Never reuse used coolant!
When replacing and removing components which rely on the corrosion protection effect of the coolant, it is essential to change the coolant. The cooling system must therefore be drained and refilled.
In the case of other removal work involving the draining of part quantities of coolant, replace these quantities which have been drained with new coolant.
Installation note:
Use only approved COOLANT .
Observe mixture ratio: 50% antifreeze and 50% water. In severely cold areas, the antifreeze can be increased to 60% which provides freezing protection down to-62°F (-52°C). Do not exceed a 60% ratio of antifreeze.