64 12... Initializing Telestart hand transmitter (T90)
WARNING: This page is about a different car, the 2013 BMW X5 M, 2012 BMW X5 M, 2011 BMW X5 M, and 2010 BMW X5 M. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The Telestart hand transmitter must be initialized when:
The independent heating is switched on under an outside temperature of approx. 15 °C with the hand transmitter and at a preselected switch-on time.
Direct activation is possible at any outside temperature via the "Climate" menu item in the i-Drive, but not in driving mode.
- Hand transmitter is replaced
- Car Access System control unit is replaced
The independent heating is switched on under an outside temperature of approx. 15 °C with the hand transmitter and at a preselected switch-on time.
Direct activation is possible at any outside temperature via the "Climate" menu item in the i-Drive, but not in driving mode.
To initialize a new hand transmitter, perform the following operations from inside the vehicle:
- Close all vehicle doors
- Within 5 seconds: Switch ignition lock from terminal "0" to terminal "R" and then back to terminal "0"
- Within 5 seconds: Press OFF button (1) on hand transmitter and with OFF button (1) held down press ON button (2) three times quickly
- Release both buttons. LED (3) on hand transmitter flashes
NOTE:
The vehicle's central locking closes and opens automatically on successful initialization.
The initialization process must be repeated if there is no checkback signal from the central locking system.
The initialization process must be repeated if there is no checkback signal from the central locking system.