65 75 071 Removing and installing (replacing) module for passenger compartment sensor

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

00 9 340

IMPORTANT: Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION) !

Lever out trim (1) with special tool 00 9 340 and remove.

Fig 1: Removing Trim With Special Tool 00 9 340

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1) and remove module for passenger compartment sensor with trim.

Replacement:

Open retaining lugs (2) and remove module (3).

Installation:

Arrow (4) printed on module for passenger compartment sensor must be aligned in direction of arrow.

Fig 2: Identifying Plug Connection, Retaining Lugs And Module

Courtesy of BMW OF NORTH AMERICA, INC.

Replacement:

Carry out PROGRAMMING/CODING .