12 90 100 Replacing fan for electronics box (N52)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 535i, 2009 BMW 535xi, 2009 BMW 535i, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Read and comply with notes on PROTECTION AGAINST ELECTROSTATIC DAMAGE (ESD PROTECTION)
.
Necessary preliminary tasks:
- Switch off ignition
- Disconnect BATTERY NEGATIVE TERMINAL
- Remove right MICROFILTER HOUSING
- Remove AIRBAG CONTROL UNIT
IMPORTANT:
Follow instructions for REMOVING AND INSTALLING ELECTRONIC CONTROL UNITS .
Unlock cover (1) with slide (3).
Unfasten screws (2).
Remove electronics box cover (1).
Installation:
Engage electronics box cover (1) correctly in hinges.
Security version:
Remove DME armor plating.
Disconnect plug connections (1 to 6).
Remove DME control unit.
Unlock plug connection (1) on fan for electronics box and disconnect.
Release screws (2) on device carrier.
Lift out device carrier (2).
Unlock vent duct (1) and remove in direction of arrow.
Remove cover (2) in direction of arrow.
Unscrew nuts.
Pull device holder (1) approx. 3 cm towards rear.
Remove air duct (1) from device holder (2).
Turn connecting piece (1) to right and remove.
Release screws and remove fan (1) in upwards direction.
Check function of DME.