32 31 070 Removing and installing / replacing lower section of steering spindle

WARNING: This page is about a different car, the 2010 BMW 528i, 2009 BMW 528i, and 2008 BMW 528i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: If the lower section of the steering spindle is separated from the power steering gear/steering column, the steering column switch cluster may be damaged when the steering wheel is turned.

If necessary, remove steering gear cover at side Release clamping screw.

Remove lower section of steering spindle from power steering gear.

Fig 1: Removing Lower Section Of Steering Spindle From Power Steering Gear

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Clean thread to remove all remnants of screw securing adhesive.

Replace clamping screw.

Lower section of steering spindle can only be attached in one position to the power steering gear.

Clamping screw must rest in steering spindle groove of steering gear.

Tightening torque 32 31 1AZ . See 31 STEERING COLUMN .

IMPORTANT: Make sure universal joint is correctly seated.

Remove trim panel for pedal assembly . See 51 45 185 REMOVING AND INSTALLING/REPLACING PANEL FOR PEDALS .

When reinstalling lower section of steering spindle: mark installation position of universal joint in relation to steering column.

Switch on ignition.

Turn steering wheel approx. 45°, hold securely and release clamping screw (1).

Turn steering wheel back and remove ignition key.

Detach lower section of steering spindle from steering column.

Installation:

Clean thread to remove all remnants of screw securing adhesive.

Fig 2: Detaching Lower Section Of Steering Spindle From Steering Column

Courtesy of BMW OF NORTH AMERICA, INC.

Replace clamping screw.

Clamping screw must rest in groove of steering column.

Tightening torque 32 31 1AZ . See 31 STEERING COLUMN .

After installation:

Turn steering wheel in both directions to full lock. The airbag warning lamp must not light up in the process.
Carry out steering angle sensor adjustment/adjustment for active front steering . See 61 31 996 CARRYING OUT STEERING ANGLE SENSOR ADJUSTMENT .
Check directional stability of car