27 10 020 Installing Replacement Transfer Case (ATC 300)
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 535xi, 2010 BMW 528xi, 2009 BMW 535xi, 2009 BMW 528xi, and 2008 BMW 535xi. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
After replacement, the "Repair" service function must be carried out with GT1.
Recycling:
Catch and dispose of escaping transmission oil. Observe country-specific waste-disposal regulations.
IMPORTANT:
After completing work, check transmission oil level and top up if necessary.
Release filler plug (1).
Check oil level.
Tightening torque, 60 N.m.
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only the approved transmission oil.
Release filler plug (1).
Check oil level.
Tightening torque, 60 N.m.
Pour in transmission oil up to lower edge of opening for filler plug (1).
Use only the approved transmission oil.
Failure to comply with this requirement will result in serious damage to the transfer case!
Necessary preliminary tasks:
- Drain transmission oil at oil drain plug
Tightening torque, 60 N.m.
- Remove transfer case