62 30 517 Adjusting Head-Up Display (Height Adjustment)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2007 BMW 550i, 2007 BMW 530xi, 2007 BMW 530i, 2007 BMW 525xi, and 2007 BMW 525i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

NOTE:

The following text only describes how to adjust the height of the head-up display.

How to CORRECT A LOPSIDED DISPLAY (DISPLAY ADJUSTMENT) is described separately.

NOTE:

Vehicles with head-up displays are fitted with special windscreens.

These windscreens are marked with the letters "HUD" on the outside at bottom right below the seal (1).

Prior to adjustment, fold seal (1) back and make sure that a correct windscreen is fitted.

Fig 1: Identifying Fold Seal

Courtesy of BMW OF NORTH AMERICA, INC.

Necessary preliminary tasks:

Check that windscreen bears the "HUD" label
Move steering wheel into maximum "lower" and "retracted" position
Unclip both sun visors from counter-supports and fold to one side
If necessary, cover windscreen (to darken the adjustment image)
Switch on head-up display.
Call up test image via diagnosis for height adjustment

Switch on test image for max. 1/2 hour.

If test image is operated for a longer period, switch fan to speed 3 to avoid overheating.

IMPORTANT:

Do not scratch windscreen when installing and removing special tool 62 1 121.

Carefully engage special tool 62 1 121 in both counter-supports (1) of sun visors.

NOTE:

If special tool 62 1 121 is difficult to engaged, if necessary release its adjusting screws and turn/switch the associated locators.

Center special tool 62 1 121 and secure with adjusting screws (2).

Fig 2: Identifying Counter-Supports With Special Tool (62 1 121)

Courtesy of BMW OF NORTH AMERICA, INC.

Check HEIGHT ADJUSTMENT using scale on special tool 62 1 121.

If height adjustment is not correct:

Remove ON-BOARD MONITOR
To avoid damage: apply fabric adhesive tape (1) in area of on-board monitor to decorative strip on instrument panel on right side (2).
Fit special tool 62 1 122 as illustrated on lock nut (3).
Release lock nut (3).
Correct height adjustment by turning eccentric.
Secure lock nut (3), tightening torque: 62 30 1AZ . See HEAD-UP DISPLAY for specs.

Switch off ignition.

Fig 3: Identifying Special Tool (62 1 122, 62 1 121)

Courtesy of BMW OF NORTH AMERICA, INC.