31 35 005 Removing And Installing/Replacing Push Rod (Stabilizer Link) For Left/Right Stabilizer

WARNING: This page is about a different car, the 2008 BMW Alpina and 2007 BMW Alpina. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe safety instructions when raising the vehicle.

NOTE: Stabilizer links may only be replaced in pairs.

Release nut; if necessary, grip brace at Torx socket.

Installation:

Replace self-locking nut.

Tightening torque. See FRONT AXLE - TIGHTENING TORQUES -- ALPINA

Fig 1: Locating Self-Locking Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut; if necessary, grip brace at Torx socket.

Remove stabilizer link.

Installation:

Replace self-locking nut.

Tightening torque. See FRONT AXLE - TIGHTENING TORQUES -- ALPINA

Fig 2: Locating Stabilizer Link Nut

Courtesy of BMW OF NORTH AMERICA, INC.