32 31 070 Removing and installing / replacing lower section of steering spindle
WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 2010 BMW X3, 2009 BMW X3, 2008 BMW X3, 2007 BMW X3, and 2006 BMW X3. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
If the lower section of the steering spindle is separated from the power steering gear/steering column, this can result in damage to the steering column switch cluster when the steering wheel is turned!
Release clamping screw.
Move steering wheel to straight-ahead position and remove ignition key.
Detach lower steering spindle from steering column and remove with double joint towards bottom.
Installation:
Recut thread.
Replace clamping screw.
Clamping screw must rest in groove of steering column.
Tightening torque: 32 31 1AZ, see 32 31 STEERING COLUMN .
Replacement:
Release clamping screw.
Pull lower section of steering spindle (1) out of double joint with flexible disk.
Installation:
Recut thread.
Replace clamping screw.
Clamping screw must rest in groove of lower steering spindle (1).
Tightening torque: 32 31 13AZ, see 32 31 STEERING COLUMN .
After installation:
- Carry out steering angle sensor adjustment, see 61 31 996 Carry out steering angle sensor adjustment .
- Turn steering wheel in both directions to full lockNOTE: The airbag warning lamp must not light up in the process.
- Check directional stability of vehicle