84 11 610 Removing and Installing/Replacing Eject Box (Cordless Keypad Handset)

Special tools required: 

• 00 9 322 
• 00 9 341 

Unlock and open storage tray (drawer).

Detach storage tray (4) as follows from function carrier:

• Release lock (3) by turning with a 1 mm feeler gauge (2).
• Pull storage tray (4) towards rear out of function carrier and set down on protective cover (1).
  Fig 1: Identifying Protective Cover, Lock & Storage Tray

  Courtesy of BMW OF NORTH AMERICA, INC.

Press button (1) and remove SIM card holder (2).

Lever cover (3) in direction of arrow out of storage tray (4).

Fig 2: Removing SIM Card Holder, Cover & Storage Tray

Courtesy of BMW OF NORTH AMERICA, INC.

Removing:

If fitted, release catches (4) with special tool 00 9 322. 

Installation: 

Following parts of cover (7) must not be damaged or missing:

1. Catches
2. Spring
3. Release button
4. Catches
5. Guides
6. Catches
   Fig 3: Identifying Catches, Spring & Guides

   Courtesy of BMW OF NORTH AMERICA, INC.

Using special tool 00 9 341, unlock insert (1) and pull out slightly in direction of arrow.

Fig 4: Identifying Special Tool (00 9 341)

Courtesy of BMW OF NORTH AMERICA, INC.

Disconnect plug connection (1).

Remove insert (3).

Fig 5: Identifying Circuit Board & Plug Connection

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Ribbon cable (1) must be laid in guide (3).

Stop (4) and damper (5) must not be damaged.

Fig 6: Identifying Damper, Ribbon Cable & Guide

Courtesy of BMW OF NORTH AMERICA, INC.

Installation: 

Springs (1) must be correctly connected in mountings (2).

Catch (3) must not be damaged.

Fig 7: Identifying Spring, Hand Mirror & Catch

Courtesy of BMW OF NORTH AMERICA, INC.