32 00 610 Adjusting Toe-In And Camber On Front Axle

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 3 140

IMPORTANT: Observe safety when raising the vehicle.
Changes in axle geometry caused by accidents must under no circumstances be rectified by camber adjustment!

NOTE: Camber and toe-in influence each other. Adjust the toe-in first in order to simplify the adjustment procedure.
The centering pin may only be driven or twisted out if the camber is outside the specified tolerance after toe adjustment.

Adjust toe-in:

If necessary, remove steering gear cover at side

Move steering into straight-ahead position by means of markings on cap (1) and steering gear (2).

Align steering wheel and secure with steering wheel arrester.

Fig 1: Markings On Cap And Steering Gear

G04766815

Courtesy of BMW OF NORTH AMERICA, INC.

Clean thread on tie rod.

Slacken clamping nut (1), gripping tie rod end (3) in the process.

Turn tie rod (2) to adjust toe-in to specified value.

Tighten down clamping nut (1).

Tightening torque 32 21 5AZ . See STEERING AND WHEEL ALIGNMENT - TIGHTENING TORQUES .

If necessary, correct installation position of gaiter.

Fig 2: Identifying Slacken Clamping Nut

G04766816

Courtesy of BMW OF NORTH AMERICA, INC.

Adjusting camber:

Remove protective cap.

Twist out centering pin (1).

Clean wheel arch from below in area of support bearing with compressed air.

Slacken nut (2) approx. 1 to 1.5 turns.

Fig 3: Identifying Slacken Nut

G04766817

Courtesy of BMW OF NORTH AMERICA, INC.

Insert special tool 32 3 140 into wheel arch opening and over nut.

Replace nuts (3) and screw on but do not tighten down fully.

Turn nut (4) in special tool 32 3 140 to adjust camber to setpoint value.

Tighten down nuts (3).

Tightening torque 31 31 1AZ . See FRONT AXLE - TIGHTENING TORQUES .

Remove special tool 32 3 140 .

Fig 4: Identifying Special Tool (32 3 140)

G04766818

Courtesy of BMW OF NORTH AMERICA, INC.

Replace nut (2) and tighten down.

Tightening torque 31 31 1AZ . See FRONT AXLE - TIGHTENING TORQUES .

Fig 5: Identifying Suspension Nut

G04766819

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Check directional stability of car; if necessary, repeat toe-in adjustment