31 35 005 Removing And Installing/Replacing Push Rod (Stabilizer Link) For Left/Right Stabilizer

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

IMPORTANT: Observe safety when raising the vehicle.

NOTE: Stabilizer links may only be replaced in pairs.

Release nut; if necessary, grip brace at Torx socket.

Installation:

Replace self-locking nut.

Tightening torque 31 35 12AZ . See FRONT AXLE - TIGHTENING TORQUES .

Fig 1: Locating Self-Locking Nut

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut; if necessary, grip brace at Torx socket.

Remove stabilizer link.

Installation:

Replace self-locking nut.

Tightening torque 31 35 12AZ . See FRONT AXLE - TIGHTENING TORQUES .

Fig 2: Locating Self-Locking Nut

Courtesy of BMW OF NORTH AMERICA, INC.