61 20 908 Run battery "Power reset" (to program/encode control unit(s))

The following steps must be carried out for a "power reset": 

• Switch off and disconnect battery charger
• Switch off ignition

  For vehicles with ignition key:  Ignition key in position 0

  Vehicles with ID transmitter:  Remove ID transmitter from slot

  Vehicles with comfort access system:  Secure terminal 30

• Disconnect battery negative terminal
• Reconnect battery negative terminal (to ensure bus activity)
• Waiting time (5-10 seconds)
• Disconnect battery negative terminal
• Waiting time (1 minute)
• Connect battery negative terminal and tighten, tightening torque 61 21 1AZ
• Connect and switch on battery charger
• Switch on ignition.