32 13... Fitting Repair Kit For FCD Coupling

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2008 BMW 750i, 2008 BMW 750Li, 2007 BMW 750i, 2007 BMW 750Li, and 2006 BMW 750i. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

32 1 021
32 1 022
32 1 023

Remove FCD coupling.

Only following parts can be replaced on coupling head:

FCD dirt seal
Support ring
O-ring

IMPORTANT: Support ring and O-ring must not be mixed up!
Always fit repair kit for FCD coupling completely.

Fig 1: Identifying FCD Coupling Parts

Courtesy of BMW OF NORTH AMERICA, INC.

Press in special tool 32 1 023 as far as it will go in connecting piece on hydraulic steering gear. Then pull out again.

Fig 2: Identifying Special Tool (32 1 1023)

Courtesy of BMW OF NORTH AMERICA, INC.

Remove spring ring (1) from special tool 32 1 023 .

Fig 3: Identifying Special Tool (32 1 1023)

Courtesy of BMW OF NORTH AMERICA, INC.

Lay new spring ring (1) in special tool 32 1 021 .

Using special tool 32 1 022 , press spring ring (1) into connection. In so doing, press through special tool as far as it will go.

Installation:

Bore hole in special tool 32 1 021 is conical. Special tool must rest with stepped side securely on connection of hydraulic steering gear.

Fig 4: Identifying Special Tool (32 1 1021) And (32 1 1022)

Courtesy of BMW OF NORTH AMERICA, INC.