51 14 002 Removing and installing/replacing front MINI badge

Special tools required:

00 9 322

IMPORTANT: The NOTES on component bonding with double-sided adhesive tape serve as the basis for this repair instruction and must be observed without fail.

NOTE: The MINI badge is damaged during disassembly and must be replaced.

REMOVAL:

Heat MINI badge (1) with hot air blower and carefully lever out with special tool 00 9 322 .

Fig 1: Removing Mini Badge Using Special Tool (00 9 322)

Courtesy of BMW OF NORTH AMERICA, INC.

INSTALLATION:

Pull liner off adhesive tape (1), position MINI badge over guide pins (2) on engine compartment lid and press down firmly.

Liner is the protective film on a new MINI badge.

Fig 2: Identifying Adhesive Tape And Guide Pins

Courtesy of BMW OF NORTH AMERICA, INC.