Direct Ignition System (Dis)

WARNING: This page does not describe the selected car, but rather 82 other vehicles, including the 2006 BMW M3, 2006 BMW 330Ci, 2006 BMW 325Ci, 2005 BMW M3, and 2005 BMW 745i. However, it is still accessible from the selected car via links, so may be relevant.

Ensure ignition is turned off before working on the ignition system. The engine will not start without a connected secondary circuit. When checking compression, remove Digital Motor Electronics (DME) Electronic Control Unit (PCM) relay. See DME & FUEL PUMP RELAY LOCATION table under FUEL SYSTEM PRESSURE RELEASE under FUEL SYSTEM.
Shielded capacitors may not be connected to terminal No. 1 of the ignition coil. Terminal No. 1 of the ignition coil may not be connected to ground or battery positive terminal, as this will damage ignition stages in DME control unit.
DO NOT connect DVOM or test light to terminal No. 1 of ignition coil while engine is running. High tension (350 volts) is present at coil terminal No. 4, secondary ignition leads, spark plugs and ignition coil terminal No. 1 to DME Powertrain Control Module (PCM).

NOTE: For location of DME master and fuel pump relays, see DME & FUEL PUMP RELAY LOCATION table under FUEL SYSTEM PRESSURE RELEASE under FUEL SYSTEMS .