61 31 020 Removing and installing/replacing ignition starter switch
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2010 BMW 528xi, 2010 BMW 528i, 2009 BMW 528xi, 2009 BMW 528i, and 2008 BMW 528xi. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Move ignition lock to key position 0 (stop)
- Remove LOWER SECTION OF STEERING COLUMN TRIM
IMPORTANT:
Before removing ignition starter switch (1), secure inner shaft against turning:
Insert a M2.5 x 8 screw in bore (2).
Insert a M2.5 x 8 screw in bore (2).
Installation:
Remove screw in bore (2).
Release screws (1), tightening torque 61 31 1AZ .
Installation:
Secure screws (1) with sealing paint.
IMPORTANT:
Carefully unlock and disconnect associated plug connection for ribbon cable.
Replace the ribbon cable if damaged.
The ribbon cable leads to the control unit for the Car Access System .
Replace the ribbon cable if damaged.
The ribbon cable leads to the control unit for the Car Access System .
Remove ignition starter switch (2).