61 61 270 Removing And Installing Console For Windshield Wiper System Completely With Motor
WARNING: This page is about a different car, the 2007 BMW 550i and 2006 BMW 550i. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
IMPORTANT:
Before fitting windshield wiper arms, allow wiper motor to run into rest position.
Release screws (1).
Installation:
Tightening torque: 61 61 15AZ . See WINDSCREEN WIPERS for specs.
Remove cross-strut bearing block (2) in direction of arrow.
Unfasten plug connection (1) and disconnect.
Release screws (A5...A1).
Installation:
Insert screws (A1...A5) in specified sequence until hand-tight.
To tighten down screw (A2), if necessary move complete wiper console linkage (2) into reversal position.
Tighten down screws (A1...A5) in specified sequence to tightening torque 61 61 6AZ . See WINDSCREEN WIPERS for specs.
Lever out complete wiper console (2) in direction of arrow.